River oxygen sag

Watch what a waste discharge does to the oxygen in a river. Change the flow, the pollution load and the temperature, then follow a parcel of water downstream to see where dissolved oxygen drops lowest. This is the classic Streeter–Phelps model from environmental engineering.

River and waste

River upstream of the outfall
Waste discharge
Stream behaviour
Larger for shallow, fast, turbulent streams; smaller for deep, slow ones.

The river

0 mg/Lsaturation

How it works

  • Mixing. Just below the outfall the river and waste mix completely. Flow-weighted averages give the starting BOD L₀, oxygen DO₀ and temperature.
  • Oxygen demand. Bacteria use oxygen to break down the waste: L(t) = L₀·e−kdt.
  • Oxygen deficit. D = DOsat − DO. It grows from deoxygenation and shrinks from reaeration through the water surface: D(t) = [kdL₀ / (kr − kd)]·(e−kdt − e−krt) + D₀·e−krt.
  • Critical point. The lowest oxygen occurs at tc = [1 / (kr − kd)] · ln{ (kr/kd) · [1 − D₀(kr − kd) / (kdL₀)] }. Distance = velocity × time.
  • Temperature. Rates are corrected as kT = k20·θT−20 with θ = 1.047 for deoxygenation and 1.024 for reaeration. Saturation DO comes from a standard freshwater table (0–35 °C, sea level) by interpolation.

Rates used here are typical textbook values and defaults are for learning. Real rivers need measured kd and kr. The model assumes one steady discharge, a single straight reach, no algae, sediment demand or tributaries, so use it to understand cause and effect, not to permit a real discharge. If DO would fall to zero the model's equations stop being valid and the page says so.