Soil texture triangle

Enter your sand, silt and clay results. The tool plots the soil on the USDA texture triangle, draws guide lines to each axis, and names the soil class. Add several samples to compare them on one chart.

Your results

Sieves alone only separate sand. Silt and clay come from a hydrometer or pipette test, so the triangle needs all three.

Sand, retained on each sieve
From hydrometer or pipette
Not used in the triangle
Move over the triangle or tap it to read a point. Your guide lines appear after you enter results.

Result

Clay
Silt
Sand

How this works

  1. Texture uses the fine earth only. Gravel (larger than 2 mm) is left out. Sand, silt and clay are re-scaled so they add up to 100%.
  2. Size limits follow the USDA system: sand 2 to 0.05 mm, silt 0.05 to 0.002 mm, clay below 0.002 mm. A lab that uses a 0.075 mm sieve, as in engineering soil tests, will find slightly less sand than this system expects.
  3. Reading the chart: clay is read on the left edge, silt on the right edge and sand on the bottom edge. The dashed guide lines run from your point to each axis, so you can see where each value sits.
  4. The class is calculated from the standard USDA boundaries. Points close to a boundary are flagged, because a small lab error can change the class.
  5. Everything runs in your browser. Nothing you enter is sent anywhere.