Normal force N
Friction f
Acceleration
State
Tilt the plane
Try this
- Raise the angle slowly while the block rests. Friction grows to match mg sinθ until the block just starts to slip.
- Find the angle where it slips, then compare with tan-1μs, the angle of repose.
- Double the mass. Does the slipping angle change? Does the acceleration change?
- Set μk to 0.05 on a steep plane and compare with a rough one.
The equations
N = mg cosθ mg sinθ pulls down the slope
At rest: f = mg sinθ (while f ≤ μsN)
Sliding: a = g (sinθ − μk cosθ)
Angle of repose: tan θ = μs
Uses g = 9.8 m/s². The block starts near the top of a 3 m slope and stops when it reaches the bottom. Needs μk ≤ μs to make sense, so the sliders keep that order.